12-12-2010, 10:19 AM
Nice tip.I took a slightly different approach, I needed to make some metal fencing so what I did was to take some plain .020 styrene,figure out the spacing and then using the backside
of the point on a pocket knife and score the lines. Once painted,the results were good,however next tome I will use a thicker styrene just to avoid the possibility
of going through the sheet.
Bob
of the point on a pocket knife and score the lines. Once painted,the results were good,however next tome I will use a thicker styrene just to avoid the possibility
of going through the sheet.
Bob