03-10-2012, 09:33 AM
You make some very good points about working within a manageable size ......all of us , experienced or not , should take heed .
I tore down my steel mill layout a couple of years ago . It was , admittedly , too big for me to finish . I work alone on the layout and was not wanting to admit " failure" for a while but finally did face reality ....GO SMALLER !
Your N scale makes a lot of sense for a lot of people but , as much as I admire N scale results , it's not comfortable for me to work on . I have good eyesight but find that even HO details are hard to work on after an hour or two .
Terry
I tore down my steel mill layout a couple of years ago . It was , admittedly , too big for me to finish . I work alone on the layout and was not wanting to admit " failure" for a while but finally did face reality ....GO SMALLER !
Your N scale makes a lot of sense for a lot of people but , as much as I admire N scale results , it's not comfortable for me to work on . I have good eyesight but find that even HO details are hard to work on after an hour or two .
Terry
To err is human, to blame it on somebody else shows management potential.