Sailormatlac 2012 Resolution Challenge

[sailormatlac]

Matt,

This is looking better and better every day. It is amazing how much you are accomplishing in a short amount of time. Ok, I just realized that you are in the “Resolution Challenge”, so now it makes sense.

How did you cut the ABS plastic pipe to get a clean, square end in order for you to cap it with styrene and what type of glue or solvent did you use to make the bond?

Mark

Mark,

I cut the ABS pipe with my table saw. The safest trick to get a perfect square cut is to clamp the pipe with 2 wood blocks to avoid the pipe to spin (safest). You use the gaurd and the sliding guide too.

That's a great mock up. Feels like railroading already!
Ralph

It's about time to order tracks!

BTW, you remember when I let down Christie Brown and Canadian Breweries warehouses. We finally built them on the club layout last night... Recycling good ideas!!!

Matt