Using Locks on Switches While Operating
#24
Ops session coming up this Sunday. Got a couple of locks put on at the Hobby Industrial area. These are installed on the two turnouts from the main at each end of the siding. I'll let the crews use those two and see what they think , then the decision will be made whether to add more.

I did a bit of switching just to see how it felt, so far, the locks seemed to add to the realism and enjoyment. Still, maybe it is just the novelty, may grow old after awhile. On that note, since most of my operators would only be around every other month or so, maybe the novelty would not grow into tedium for them?

The installation was pretty clean and straightforward...

   

   
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)