10-19-2012, 04:26 AM
Still waiting for PSC parts.
Meanwhile i did test driving and decoder programming. There was still a little bind caused by the valve gear cranks.
These were not bored right at a 90° angle, sitting slanting onto the crank pin and touching the main rods at every turning :cry:
No wonder that there is bind
So i milled them to create certain "oval" borings so that they will fit in a right angle.
Then i glued and secured them with CA.
So nothing happens really worth to be photographed.
Still waiting for PSC parts.
Lutz
Meanwhile i did test driving and decoder programming. There was still a little bind caused by the valve gear cranks.
These were not bored right at a 90° angle, sitting slanting onto the crank pin and touching the main rods at every turning :cry:
No wonder that there is bind
So i milled them to create certain "oval" borings so that they will fit in a right angle.
Then i glued and secured them with CA.
So nothing happens really worth to be photographed.
Still waiting for PSC parts.
Lutz