12-07-2012, 02:08 PM
TodayI could do a little on the steeple cab:
I had to do some milling.
Then the marked area had to be lowerd for 2mm.
Then I milled the bottom of the tank down to level of the screw stops.
Then the red marked area of the tank had to be milled on both sides away. Thus there was only a 1.5 mm left, here shown in green, on as a support for the shell. This will be build from 2mm polystyrene.
Currently the framework gets a new black coating.
I had to do some milling.
Then the marked area had to be lowerd for 2mm.
Then I milled the bottom of the tank down to level of the screw stops.
Then the red marked area of the tank had to be milled on both sides away. Thus there was only a 1.5 mm left, here shown in green, on as a support for the shell. This will be build from 2mm polystyrene.
Currently the framework gets a new black coating.
greetings from northern Germany
Joerg
Indiana City, my layout
http://www.the-gauge.net/forum/viewtopic...=46&t=5379
Joerg
Indiana City, my layout
http://www.the-gauge.net/forum/viewtopic...=46&t=5379