Static grass applicator

[torikoos]

Can you post a pic of the wires and circuit board.

I'm afraid not, after I modified the fly swatter, I hot glued everywhere inside and I won't be able to open it again on that area, just the battery compartment is accessible.

Having said that, it really isn't complicated, get an electric fly swatter, open the handle, cut off the two wires that go to the swatter bit (leaving as much wire as possible), solder one of them to the tea sift, the other gets extended and attached to a nail, and fix it all in place, (in my case with loads of hot glue etc), and you're basically done.

Cheers, Koos