01-26-2013, 07:35 PM
Well, getting off my duff is not too distant a stretch then being off my rocker
I began the Challenge by attaching the cow catcher to the front of the body assembly.
You can see here that the front (Right end) is solid, 2 pieces of plastic that can be detached.
I then used the grinding wheel to cut out the plastic in the top section to make room for the frame of the catcher.
Then, since the catcher has 2 mounting screws, I had to drill holes in the bottom piece for the screws:
And here it is with the cowcatcher in place:
I began the Challenge by attaching the cow catcher to the front of the body assembly.
You can see here that the front (Right end) is solid, 2 pieces of plastic that can be detached.
I then used the grinding wheel to cut out the plastic in the top section to make room for the frame of the catcher.
Then, since the catcher has 2 mounting screws, I had to drill holes in the bottom piece for the screws:
And here it is with the cowcatcher in place:
~~ Mikey KB3VBR (Admin)
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???