01-21-2009, 01:37 AM
I just picked up a pair of Super Detailed UP DDA40X's from Bachmann (SPectrum). I would like to add LED lights (including replacing the strobe on the roof). I was told I could put a single decoder in to run both motors in each unit, IF the motors only put out so many amps. I am an electrical IDIOT. I can barely change a household light bulb. I mean, I seriously SUCK at anything electrical, but I am good with directions, so, I am confident I can handle it with the assistance of the patient folks here at the Gauge. I know Deano has one of these, how did you install DCC in yours Deano? I would like to eventually do sound in them as well, has anyone ever attempted that?
Thanks in advance for any help!
Thanks in advance for any help!
Tom Carter
Railroad Training Services
Railroad Trainers & Consultants
Stockton, CA
<!-- m --><a class="postlink" href="http://www.railroadtrainingservices.com">http://www.railroadtrainingservices.com</a><!-- m -->
<!-- e --><a href="mailto:tomwcarter@railroadtrainingservices.com">tomwcarter@railroadtrainingservices.com</a><!-- e -->
Railroad Training Services
Railroad Trainers & Consultants
Stockton, CA
<!-- m --><a class="postlink" href="http://www.railroadtrainingservices.com">http://www.railroadtrainingservices.com</a><!-- m -->
<!-- e --><a href="mailto:tomwcarter@railroadtrainingservices.com">tomwcarter@railroadtrainingservices.com</a><!-- e -->