MYO utility line stringing tool

[gary60s]

Wire attaching lugs on alligator clip should be straightened and bent in opposite direction so you can attach it to the long eyelet wire.

Pic d shows alligator clip attached to long wire by bending lugs around wire, and set in vice for soldering.

Pic e shows alligator clip soldered in place.

Pic f shows long wire bent to shape. Bends are not critical, but bottom short leg should be cut to 3/8" in length.

Pic g shows bobbin support arm inserted into base (tight fit, but easily twisted in). Glue bobbin insert into bobbin with plastic solvent cement.

Slide bobbin onto arm and then slide piece of #14 insulation onto arm end. Make sure bobbin rotates freely.