02-17-2009, 05:35 PM
Hi All,
I normally use feed the toe of a turnout with power from the bus use ....... isolating joiners on all four roads coming out and add four droppers after the isulating joiners.
If i leave a gap between the end of the turnout and the following lines would this be sufficient to isolate the turnout rather then use isolating joiners still wiring as above ? the HO joiners are a little obtrusive if it would work this way i would prefer it.
Many thanks
I normally use feed the toe of a turnout with power from the bus use ....... isolating joiners on all four roads coming out and add four droppers after the isulating joiners.
If i leave a gap between the end of the turnout and the following lines would this be sufficient to isolate the turnout rather then use isolating joiners still wiring as above ? the HO joiners are a little obtrusive if it would work this way i would prefer it.
Many thanks
<!-- m --><a class="postlink" href="http://www.freewebs.com/upnick/">http://www.freewebs.com/upnick/</a><!-- m -->