06-18-2016, 03:10 PM
You did not by accident set CV 5 to zero?
If nothing helps you must write "8" into CV "8". That resets the decoder. Give it a try with the GP38-2.
I am not sure if Intermountain specific settings will be reset too with the CV8=8 general reset. Start with the GP38-2. It should be at address 3 again.
btw. Are you sure reading and writing CVs works technically ok? Make a short test with CV 2. Write some values below 5 and read them back. Set it back to 0 at the end of the test.
ps. I had a look into the MRC prodigy wireless manual (PDF) file. Your controller does some user friendly CV 19 programming under the hood. I have never seen or done that. It might be a handling problem with the prodigy device I am not aware of. I was under the impression you do manually reprogram CV 19. Looks like your prodigy device does it for you. May be some one with dedicated prodigy experience steps in here?
If nothing helps you must write "8" into CV "8". That resets the decoder. Give it a try with the GP38-2.
I am not sure if Intermountain specific settings will be reset too with the CV8=8 general reset. Start with the GP38-2. It should be at address 3 again.
btw. Are you sure reading and writing CVs works technically ok? Make a short test with CV 2. Write some values below 5 and read them back. Set it back to 0 at the end of the test.
ps. I had a look into the MRC prodigy wireless manual (PDF) file. Your controller does some user friendly CV 19 programming under the hood. I have never seen or done that. It might be a handling problem with the prodigy device I am not aware of. I was under the impression you do manually reprogram CV 19. Looks like your prodigy device does it for you. May be some one with dedicated prodigy experience steps in here?
Reinhard