11-27-2016, 09:58 AM
This morning's job on the 0-6 build was to install the other side of the disconnect to the drive and work on the back up light. I soldered the leads directly to the motor and was able to tuck it away into the cast frame.
A diode and white LED were installed to the tender wiring. I filed the rounded tip of the LED flat and glued the clear plastic insert from the headlight casting to it with Testors clear parts. The results were exactly what I was looking for. cement.
A diode and white LED were installed to the tender wiring. I filed the rounded tip of the LED flat and glued the clear plastic insert from the headlight casting to it with Testors clear parts. The results were exactly what I was looking for. cement.
My other car is a locomotive, ARHS restoration crew