11-30-2016, 01:11 PM
I have a question about the tip.
The tip is usually the part that needs to be replaced first and after some use again and again. It is also often necessary to have more then one tip at hand. e.g. a very fine for delicate tasks at fine PCB and a more wide one to solder rails.
1. How to you get replacement tips?
2. How to you get larger tips to solder rails etc.?
You should at least have a source for replacement tips or be prepared to dump the whole thing when the first tip is used up.
ps. the name "SMD DesolderingSolder Iron" might be the reason why it has an extreme fine tip.
The tip is usually the part that needs to be replaced first and after some use again and again. It is also often necessary to have more then one tip at hand. e.g. a very fine for delicate tasks at fine PCB and a more wide one to solder rails.
1. How to you get replacement tips?
2. How to you get larger tips to solder rails etc.?
You should at least have a source for replacement tips or be prepared to dump the whole thing when the first tip is used up.
ps. the name "SMD DesolderingSolder Iron" might be the reason why it has an extreme fine tip.
Reinhard