12-09-2018, 07:52 PM
I had a chance this morning to finish off lighting circuit again on the H9.
I used the same styrene round tubing to slip the Miniatronics 2 socket harness through for some wire management and glued(CA) it on top of the rectangular tubing I used for 4 socket harness.
I substituted 4 nylon 2/56 screws for the brass ones that come with the kit to secure the base to the tender.
And gave everything a test.
I've been really impressed at how quiet the locomotive is now with the Bachmann trucks and the NWSL can motor. I still wish there was a little more top end speed, though. It's topping out at 47 scale mph. I think 60 would be a bit more where I'd like to be at.
I did notice today that I forgot to paint the new tender base black. Its suppose to be in the 50's over the weekend here so I might give it a shot then.
I'd like to give the H9 test up at the club to see how it preforms, too. Then figure out what to do next.
[url=https://s1081.photobucket.com/user/bowser0227/media/IMG_1140_zpsjpapnont.jpg.html][/url]
I used the same styrene round tubing to slip the Miniatronics 2 socket harness through for some wire management and glued(CA) it on top of the rectangular tubing I used for 4 socket harness.
I substituted 4 nylon 2/56 screws for the brass ones that come with the kit to secure the base to the tender.
And gave everything a test.
I've been really impressed at how quiet the locomotive is now with the Bachmann trucks and the NWSL can motor. I still wish there was a little more top end speed, though. It's topping out at 47 scale mph. I think 60 would be a bit more where I'd like to be at.
I did notice today that I forgot to paint the new tender base black. Its suppose to be in the 50's over the weekend here so I might give it a shot then.
I'd like to give the H9 test up at the club to see how it preforms, too. Then figure out what to do next.
[url=https://s1081.photobucket.com/user/bowser0227/media/IMG_1140_zpsjpapnont.jpg.html][/url]