10-09-2017, 02:59 PM
Doing a quick check on the grabs for the C-liner 'b'
As I mentioned an 'a' unit set gives me enough grabs to do one side of a 'b'
I could use the kit grabs on one side, and bend wire for the other side but you will notice that the kit grabs have either a curved or angled piece below the bottom mounting pin. Or I could just bend a whole set of grabs for both sides so they would match on the engine but would be a bit different than the 'a' unit that it will be running with.
As I mentioned an 'a' unit set gives me enough grabs to do one side of a 'b'
I could use the kit grabs on one side, and bend wire for the other side but you will notice that the kit grabs have either a curved or angled piece below the bottom mounting pin. Or I could just bend a whole set of grabs for both sides so they would match on the engine but would be a bit different than the 'a' unit that it will be running with.