WARP 10 Car Kits

[Schraddel]

Hello,


Next were doors and door rails. The with brass stripes reinforced door rails were quite stable.
I measured the distance between sidewall and door how much space is there between.It was 0.8mm here and i cut some 0.8mm styrene sheet to fit into the door space.





So the thin door castings were glued full faced and will have no chance to warp anymore.

Note: Here the doors are those areas where you will grab the car inevitable with your 5-finger crane to handle it.





The straightened and reinforced door rails were then an easy task to mount.


Lutz