Posts: 2,565
Threads: 63
Joined: Dec 2008
A note from MR says that Bowser are having a parts clearout. I can't use any, but someone here might.
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Posts: 11,041
Threads: 250
Joined: Dec 2008
Thanks David, I will check Bowser out.
I managed to cut the grass in my back yard today and it was still too wet to do the front. The front is a little over a half an acre and only takes bout 45 minutes. Tomorrows rain is supposed to hold off until after noon so maybe I can beat the rain.
I worked on putting a decoder in a brass RT624. I got the speaker in place and a can motor installed and new drive shafts made and installed and bench tested. The only difference between the front and rear that is readily noticeable is what looks like conduit and a switch box on the front end There are supposed to be a difference in cab windows too.
It looks like there will be plenty of room for the decoder and a current keeper. I will put a few details and photos on my layout thread when I get time tomorrow.
Tomorrow (now today) is Friday. The 12 years of school seemed to drag along yet the 161/2 years I have been retired have flown by.
Happy week end,
Charlie
