09-02-2018, 03:45 PM
Here it is with the switch and nameplates installed. I had to close off the old start button location also. I re-inked the old nameplates and reused them for a more finished look.
This shows the back side of the mounting.
The last thing that needed to be done was to make up a legend that tells you what each terminal does in each position. I went over the switch with an ohm meter and printed out my findings. I laminated it to the back of the cover with some clear packaging tape.
This shows the back side of the mounting.
The last thing that needed to be done was to make up a legend that tells you what each terminal does in each position. I went over the switch with an ohm meter and printed out my findings. I laminated it to the back of the cover with some clear packaging tape.
My other car is a locomotive, ARHS restoration crew