05-07-2021, 05:46 PM
(05-07-2021, 03:12 PM)doctorwayne Wrote: I dunno, Jim, but if you're going to be able to mill sheet plastic, why not use a suitably-sized hunk of clear pine or hard maple to make the columns - that would at least eliminate the assembly process.
Wayne
thought about that as i have some black walnut but it comes back to the same problem of trying to produce three pieces that are identical , i also thought about a 1/4 inch square rod . if i had a rotating table i could set mill head at proper angle , but a small rotating table is around 400$ .
Jim