|
DCC install question
|
07-11-2022, 11:46 AM
(07-11-2022, 09:16 AM)DanRaitz Wrote: If you're using a single decoder to run both motors, could the leads between the motors be reversed? (just a suggestion). Good suggestion Dan. The motors are wired in parallel but they run in opposite directions, with a drive shaft between them. one motor goes to each truck. That worked on DC but might be a problem with DCC. Thjanks Charlie |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
DCC install question - by Charlie B - 07-10-2022, 12:27 PM
RE: DCC install question - by BR60103 - 07-10-2022, 07:25 PM
RE: DCC install question - by Charlie B - 07-10-2022, 09:16 PM
RE: DCC install question - by DanRaitz - 07-11-2022, 09:16 AM
RE: DCC install question - by Charlie B - 07-11-2022, 11:46 AM
RE: DCC install question - by Schraddel - 07-11-2022, 04:14 PM
RE: DCC install question - by Charlie B - 07-11-2022, 05:10 PM
RE: DCC install question - by Schraddel - 07-12-2022, 06:01 AM
RE: DCC install question - by Charlie B - 07-12-2022, 07:40 AM
RE: DCC install question - by TMo - 07-12-2022, 03:53 PM
RE: DCC install question - by woodone - 08-19-2022, 07:07 PM
RE: DCC install question - by Charlie B - 08-19-2022, 09:08 PM
RE: DCC install question - by Schraddel - 08-21-2022, 01:08 PM
RE: DCC install question - by Charlie B - 08-21-2022, 01:34 PM
RE: DCC install question - by Charlie B - 12-04-2022, 03:20 PM
|
