Rainbows in the Lehigh Valley Gorge

[TMo]

With the foundation built (and level), this job MAY get easier....

The basic exterior is nothing more than joining together sidewalls of the "Small Steel Mill" kit.  I had 15 inches to cover on the short side, and each of the sidewalls is nearly 5 inches wide, so three sections were laid out, measured for overlap, and the edges folded over to accomodate the corner, and windows inset back from the front face.  The kit comes with additional steel siding that you can overlap over the existing printout, but on something of this scale, I think it's overkill (I may change my mind).  The section on the left was done with an ink cartridge that was almost expended, so I got a different color combination.  I figure I can always adjust with paint or PanPastels if I think the transition is too harsh.

   

Pinned the first story in place to get an idea of scale and how many of these stories I'll implement vertically - I'm going one story at a time with only a basic concept in my head.  After I get a full wall section together, I'll reinforce the whole deal with foam board supports which will join all of the walls and roofs together.