Bowser ALCo RS-3

[Schraddel]

Hello,


For comparison, on the left is the 13 x 18 x 13mm speaker which i accustomed to and which i want to be in this loco too.



So let's go to the tractor tool box an fetch some serious hacksaw.

The weight on the front end was cut into three pieces. The first cut was just beyond the screws holding this weight. The second cut was just to keep the holder for the tiny LED in place.






The front oddment was glued direct onto the main frame.
Both speakers were glued together and this connection reinforced by the means of a thin (0.3mm) stripe of styrene.
This block od two speakers was glued onto the weight and this connection reinforced by the means of a piece of 4 x 4mm styrene rod to enlarging the adherend.
The rear oddment of the weight is still fastened by it's original screws. Thus enables the loco still demountable for maintenance work.


It sounds much better!

Cubic capacity can be replaced by nothing, excerpt by still more cubic capacity. Q.E.D.



Lutz