VERY crude experiment with turnout control.
#25
The third turnout was a challenge. When I first set this turnout in place years ago the throw bar was too long and snagged against the turnout next to it. I rashly cut the bar off! So....no throw bar to connect my fishline to! I ended up drilling holes inside the turnout and fashioned a small bent nail connection attached to the points. I'm a little worried the super glue might not hold it in place, but so far so good after a few hours and a few trials of switching the turnout. The up side is the mechanism is even more subtle on this one. I'll ponder painting the green line black or gray.

[Image: 001-1.jpg]

Here is how the fascia looks with three installed turnout controls.

[Image: 002-3.jpg]
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)