Roundhouse 0-6-0 vs DCC/Sound

[Steamtrains]

You can make a simple jig for forming the pipe radiators. Draw some parallel straight lines on a board, spacing them the same distance apart as the coils you want. Drive some finishing nails at the ends of the lines (or at whatever length of coil you require) and then simply follow the lines with some soft brass wire of suitable diameter. You may have to use pliers to hand-form each bend where the pipe folds back on itself, but you could also place short lengths of suitably-sized brass tubing over the finishing nails, and form the bends around them.

Wayne

When he first mentioned his problem, this is exactly what came to mind....