issues with track... please help!

[Wiredup]

Take a deep breath and give yourself a pat on the back for figuring out the problem areas, developing a plan on how to fix it, and having the desire to build it again. It's a pain to do the rework, but I'd bet you'll be happier with the changes you make to your future design. Seems like every time I rework a place, I like the end result better than what was replaced.

Well thats the thing... I realy don't know how much I wanna redo...

The benchwork is all in place... and I got what feels like a lot of room....

My terminal takes up 2.5ft by 9.8ft. It has a roundhouse, coaling tower, water tower, sanding tower, place for diesel refuling, and will get a small mtc shed. There is a passenger terminal, and rom for a freight house. But thats about it... hey thats all I need, but it's a big location.

Then I got a 2ft by 9.8ft section, and then two smaller 2ft by 2ft sections joining them up so it's a big square...

But I can't figure out anything I like for the other sections that works..... I like elevation changes, because I'm basing this on mountain and water areas (think interior BC in the valley) and I got structures for a small town and a lumber works... but no where to put them on my current layout.

The big problem is that I throught that I could get some crazy transitions and great looking scenery if I built the other three sections of my benchwork lower than the main section... the result is an 8 inch elevation change between the benchwork on the terminal and the rest of the layout....which is freakin huge!