Cutting Corners.

[eightyeightfan1]

I had a couple of areas on my layout that were driving me nuts. Poor planning, and bad woodworking created a couple of rough looking places.So when I started to put up a fascia with wood paneling I decided to fix these areas. These are only two.

This is area number two. Notice how close the track comes to the edge of the layout . Just didn't look right.
   

This is corner 1. After I framed it and attached the paneling.
   

And after I trimmed and fit the pink Styrofoam. Already a big improvement.
   

With Sculpta-Mold applied. The hair dryer speeds up the drying.