12-17-2013, 05:03 PM
Corners were roughly trimmed with an X-acto blade and rounded with a jeweller file.
![[Image: IMG_3157b_zps72c04bbf.jpg]](http://i603.photobucket.com/albums/tt111/sailormatlac/Hedley%20Junction/IMG_3157b_zps72c04bbf.jpg)
![[Image: IMG_3155b_zps1d33ae4d.jpg]](http://i603.photobucket.com/albums/tt111/sailormatlac/Hedley%20Junction/IMG_3155b_zps1d33ae4d.jpg)
There's still some little imperfections that will need to be puttied before adding details.
I also filler the horn holes on the cab roof with styrene rod and sanded them down.
Next step is to trim a battery box, cut the large roof fan and remove the wrong intercooler fan on each side. Also, the two carbody filters located near the cab will be cut down to make room for a 3-unit one. I'm planning to 3D print the new carbody filters and intercooling fan. Shouldn't be too hard to figure out those simplistic rectangular parts with good photograph references.
Matt
There's still some little imperfections that will need to be puttied before adding details.
I also filler the horn holes on the cab roof with styrene rod and sanded them down.
Next step is to trim a battery box, cut the large roof fan and remove the wrong intercooler fan on each side. Also, the two carbody filters located near the cab will be cut down to make room for a 3-unit one. I'm planning to 3D print the new carbody filters and intercooling fan. Shouldn't be too hard to figure out those simplistic rectangular parts with good photograph references.
Matt
Proudly modelling Quebec Railway Light & Power Company since 1997.
Hedley-Junction Club Layout: http://www.hedley-junction.blogspot.com/
Erie 149th Street Harlem Station http://www.harlem-station.blogspot.com/
Hedley-Junction Club Layout: http://www.hedley-junction.blogspot.com/
Erie 149th Street Harlem Station http://www.harlem-station.blogspot.com/