02-25-2009, 07:42 PM
I now have the "flute" painted, and installed, and the pipes have been added as well. For the pipes, I'm using a combination of Plastruct tubes and elbows, as well as some from the Walthers refinery piping kit
Here's the view from the front:
A close-up on a very thin pipe that I made out of wire:
And a view from the side:
I'm not sure what those 2 I-beams on top of the prototype tank are for, but I modelled them anyway.
cheers
Val
Here's the view from the front:
A close-up on a very thin pipe that I made out of wire:
And a view from the side:
I'm not sure what those 2 I-beams on top of the prototype tank are for, but I modelled them anyway.
cheers
Val