12-07-2023, 01:30 PM
(12-07-2023, 05:47 AM)ezdays Wrote: If it is super glue, acetone would work, but it could soften the shell. That's a lot of glue, I think I'd still try to cut it off, even an X-acto knife, but I can see where that would be difficult. One other suggestion would be to grind the tube off to the point where it doesn't interfere. Good luck.
OK. I did try the water trick but that didn't work. I want to try to cause as little damage as possible. I will give that a try with cutting it out now. All this to get the frame and motor in. Next step after getting all this done is to remove the lettering and number, then apply the decals for the C&I ( Cambria & Indiana Railroad ) and put it into service under the tree lol.
Matt
I can smell a steam post ten blocks away and when I do clear the tracks because the steam express will be hi ballin through
http://cambriaindiana.weebly.com/
I can smell a steam post ten blocks away and when I do clear the tracks because the steam express will be hi ballin through
http://cambriaindiana.weebly.com/