02-04-2024, 09:49 AM
Got though step 4 fairly well, all about adding the front seat. Problem is that five of the parts used have curves. But thanks to Jim's suggestion of steaming that I never thought of, I found that soaking in water was just as effective. Lots more curved parts to go though. So far I've used 96 out of the 298, so there's a way to go.
Here's the instructions for the last of step 4 and just about all of step 5. That step used 21 parts just for the lamp assemblies. Not difficult, but a lot of very small parts.
Here's the instructions for the last of step 4 and just about all of step 5. That step used 21 parts just for the lamp assemblies. Not difficult, but a lot of very small parts.
Don (ezdays) Day
Board administrator and
founder of the CANYON STATE RAILROAD
Board administrator and
founder of the CANYON STATE RAILROAD