06-15-2024, 08:05 PM
Well, the first "Test" print didn't do so well.
The challenge for this build may very well turn out to be the printing part.
The upper right corner of the lower car side in the picture is where it crashed.....
I'm trying again after making a few adjustments to the file....
The challenge for this build may very well turn out to be the printing part.
The upper right corner of the lower car side in the picture is where it crashed.....
I'm trying again after making a few adjustments to the file....
~~ Mikey KB3VBR (Admin)
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???