Lighting for Layout?

[doctorwayne]

As long as the actual curve of the coved section is above layout height, simply extend the layout framing beyond the structures that are already in place, and slip the "new" end of the benchwork under the cove. As an alternative, you could fasten a square of benchwork into the corner, then butt the already-finished sections up against that. With part of it under the cove, you'd need to add only a little scenery to tie it in with the rest, and, of course, the track.

Here's a rough sketch illustrating the idea, with the layout surfaces representing already-built sections - simply add a new piece (or an extension from either section) to fill-in the corner. This corner piece would fit below the bottom edge of the cove:


Wayne