12-14-2009, 05:36 PM
I know, I know!! I'ts been awhile. I am slowly but surely making progress on the layout. I have been busy making "test runs" over what track I have laid down.
Yes, when I saw that engine repair shop, I just had to have it, and since I had a $50.00 budget, I grabbed it!! (It was only $8.00!!)
I have a question, since the bottom is glued on, and the doors are glued in place, how can I safely remove the doors, so that I can have them open? I'd like to be able to actually run some locos, etc, into the shop.
Yes, when I saw that engine repair shop, I just had to have it, and since I had a $50.00 budget, I grabbed it!! (It was only $8.00!!)
I have a question, since the bottom is glued on, and the doors are glued in place, how can I safely remove the doors, so that I can have them open? I'd like to be able to actually run some locos, etc, into the shop.
I only know what I know, and I don't understand very much of it, either.
Member: AEA, American Legion, Lions Club International
Motto: "Essayons"
Member: AEA, American Legion, Lions Club International
Motto: "Essayons"