07-24-2010, 12:29 PM
Tom, if all my bridge supports are from styrene, and I use a heat gun to melt the water pellets, won't I also melt the supports?
Also, the water in the bayou is a murky greenish brown. So paint the color onto the bottom of the bayou and then put a thin layer of the EZ water on top? I'm trying to remember how DocWayne did his water.... I think he painted the bottom and then used gloss medium brushed on top? DocWayne?
Well, I am off to the layout room to start the initial terrain building at the bridge location... knife, faom glue, wire brush, and a shop vac.
Also, the water in the bayou is a murky greenish brown. So paint the color onto the bottom of the bayou and then put a thin layer of the EZ water on top? I'm trying to remember how DocWayne did his water.... I think he painted the bottom and then used gloss medium brushed on top? DocWayne?
Well, I am off to the layout room to start the initial terrain building at the bridge location... knife, faom glue, wire brush, and a shop vac.
Three Foot Rule In Effect At All Times