01-30-2012, 11:16 AM
Test run was successful, ran my smallest engine on all the tracks and through both turnouts without stalling or light flickering of any kind. Feels good!
Here's what the underside of the section looks like with the wiring finished, connection to the control panel will be via the long connector strip in the center:
![[Image: 2157_w1200.jpg]](http://www.hjemstad.no/pics/2012/01/2157_w1200.jpg)
Now it's time to get started on the third and final section. First order of the day is to prep the last turnout, mount the motor and accessory switch, and solder some feeders to the stock rails and the frog, then I can begin to tidy up all those loose wires hanging underneath.
Svein
Here's what the underside of the section looks like with the wiring finished, connection to the control panel will be via the long connector strip in the center:
Now it's time to get started on the third and final section. First order of the day is to prep the last turnout, mount the motor and accessory switch, and solder some feeders to the stock rails and the frog, then I can begin to tidy up all those loose wires hanging underneath.
Svein