Well, the first "Test" print didn't do so well.
The challenge for this build may very well turn out to be the printing part.
The upper right corner of the lower car side in the picture is where it crashed.....
I'm trying again after making a few adjustments to the file....
neat mike i have thought about trying 3d printing but have too many things on the plate right now, boy has been looking into to print passenger car interiors.
Jim
(06-16-2024, 08:52 AM)tompm Wrote: That is a big difference. 3D printing is something I wish I could do but I feel the learning curve would be too much.
Just a quick update:
I'm taking my time with this since I'm designing as I go along.
This is a G, 1:20 scale Yard Cart.
Proto measurements would be approximately 8 ft X 8 Ft
I have yet to try to design & print the front & rear bumpers and also the coupler mount.
Still thinking on the easiest way to do that.