Should you ever get the "itch" to put table cloths , plates, and flower vases on your tables - - - -
This circular cover was made from a single ply of tissue. I wetted the tissue, on a table, and used a piece of styrene tube to hold the edges down while it dried. Once dry, I removed the tube, and applied a water/white glue mix to set it, and fix it in place.
You would have to find or build a square/rectangular "box" to do the same thing with your tables.
The flower vases: A small round red bead, with a little green foam.
The plates: I purchased a 9 piece "Leather Punch Set", to cut circular pieces of styrene sheet for SciFi models. ( among other things ) The plates were cut from .005" Styrene ( Evergreen ) with the punch that was closest to 10 scale inches in diameter.
These disks were set on my Cutting Mat. it was just the right softness to allow the making of the center depressions of each plate with an appropriately sized pin punch. Yeah, I did punch the center completely out....until I found the right amount of force with the hammer. :o
The punch set I have came from Hobby Lobby, but any place that includes leather working tools should have one.
I haven't tried "silverware" yet, some clear acrylic rod, could be cut to make water glasses. You can just see them on the clear glass table, here.
We always learn far more from our own mistakes, than we will ever learn from another's advice.
The greatest place to live life, is on the sharp leading edge of a learning curve.
Lead me not into temptation.....I can find it myself!