12-28-2020, 10:17 AM
Just a note to show that it's been a long while since I did any scratchbuilding. While starting on my new building:
#1, I forgot that I had my CAD page set to 9"= 1' and that my printer would print accordingly.
#2, I went ahead and cut out all 14 window and door openings before I checked one for size.
#3, Reset my CAD page to 12" = 1' and started all over again.
#4, Severely reprimanded myself for such rookie stupidity.
#5, Reminded myself that it's just a hobby and rookie mistakes are OK and correctable.
#6, Thanked myself for using soft plastic sheets that cuts easily with an X-acto knife, rather than using styrene.
#1, I forgot that I had my CAD page set to 9"= 1' and that my printer would print accordingly.
#2, I went ahead and cut out all 14 window and door openings before I checked one for size.
#3, Reset my CAD page to 12" = 1' and started all over again.
#4, Severely reprimanded myself for such rookie stupidity.
#5, Reminded myself that it's just a hobby and rookie mistakes are OK and correctable.
#6, Thanked myself for using soft plastic sheets that cuts easily with an X-acto knife, rather than using styrene.
Don (ezdays) Day
Board administrator and
founder of the CANYON STATE RAILROAD
Board administrator and
founder of the CANYON STATE RAILROAD